AIR RIFLE FOR FISHING
Hello bro, one barrel greeting guys. Since, there were some messages I got from the readers about the air rifle for fishing. This time I want to discuss tips on modify fish rifles. Initially I was not corncern on this type of fish air rifle, but because of the most customers request. I finally tried to post the tips on modifiying air guns for fishing. Homefully it can enrich our insight and help you who want to fish.
The system of air rifle for fishing and standard air rifles has no big differences. The differences are only in the barrel and the addition of some arc components. In this post I use a PCP type air rifle to modify fish rifles. Don’t look down at the rifle, because the rifle I used is scratched and it’s not for sale. We install the PCP wind rifle without grooves or plain. Since the bullet used is an iron arc. We tie the bow to the back with a thread. While the thread used to modify the fish gun is not just any thread, but a special thread that is small, flexible and strong. Because when we use a thread with a relatively large diameter it will inhibit the arc path to move.
This temprorary thread roll mechanism still uses manual roll. By using PVC pipes as a place to roll threads. When installing a roll pipe on a modified air rifle for fishing you should pay attention to several sides so as not to collide with the wind filling nipple. For those who use hand pump type rifles, the placement of the roll pipes should be adjusted so that is does not interfere when pumping an air rifle. If you look at a glance, in fact the modified fish gun is quite easy. Just adding a few components and adjusting the pipe roll thread so as not to interfere with the pump mechanism.
From the photo above, you can clearly see how the modified fish gun we have made works. If you have feedback and comments, please fill in the comments below this post. Thanks you and one barrel greet from me.