SPRING HAMMER MODIFICATION
Air rifle with maximum power is the dream of all air rifle users. A lot of things have to be done to increase the firepower of the air rifle. From raw materials for making air rifles to the addition of additional supporting components. This time I will give tips to you about spring hammer modification.
Spring hammer is one of the PCP component which serves to suppress the hammer and give a knock to the valve so that air pressure is transferred from the tube into the chamber which is forwarded to throw bullets. Without the stong pressure of spring hammer the fire power produced is less than optimal. Another way to make the pressure of spring hammer stronger rather than replacing it with a stronger one. you can also install the suit components of spring hammer. Components of the suit spring hammer are made of brass and are quite easy to install.
The suit component of spring hammer is installed right behind the hammer. By removing the pipe cap and replacing it with spring hammer modification component. The spring component size is adjusted to the diameter of the house pipe spring hammer. If you found it difficult in making the components you can order to the gun shop. Don’t forget to measure the diameter of the home tube spring hammer so that it adjusts. Home tubes spring hammer on a air rifle usually use brass pipes with diameter of 16mm, 19mm, 22mm and 25mm. The instaling of eace pipe’s size the same.
With this modification the power and accuracy of our air rifles will increase. However, with a strong spring setting will make our air rifle waste wind so that is can cause fewer shots than before modification.
Hoppefully this article about spring setting modification can help you in raising your power air rifle. Thank you.